ILI9225 Full Color TFT Display Board [2.2 inch] [176x220 Pixel]

Description:
ILI9225 Full Color TFT Display Board is 2.2 inches with a resolution of the 176x220 (16 bit RGB) pixel, full-color TFT display, which is controlled by ILI9225 display driver chip. The TFT Display interfaces and communicates with the microcontroller over SPI, so while using it, it must be connected to the SPI pins of the Arduino. TFT display can be supplied with logical voltage (3.3V) and 5V, but it can't directly connect to 5V,  before that, it must be applied a voltage regulator, otherwise, the display may be damaged. Some TFT display module has a built-in voltage regulator and can be connected directly to the 5V. If the display does not have a voltage regulator, it can be used any logic level converter between the display and the Arduino.
This module is equipped with an SD card slot for expanding its function, conveniently. It displays up to 65,000 different colors with 16bit RGB. It can directly be added to Arduino Mega or Uno, through the 4-wire SPI interface. It is made by military-grade process standards, so can work long-term stable. Its low-level libraries and rich sample programs for Arduino, C51, and STM32 platforms are provided. 

Features:
Type: TFT LCD
Driver IC: ILI9225
Size: 2.2 inch
Resolution: 176 x 220 Pixel
Display color: 16BIT RGB 65K color
Interface type: 4 wire SPI
Operating Voltage: 3.3V, 5V
Display area size: 34.848mm x 43.56mm
PCB size: 42.46mm x 67.20mm
Operating temperature: -10°C ~ 60°C
Power consumption: About 90mw

11PIN Standard wiring used IO: 
1. VCC--Power supply (5V/3.3V) 
2. GND-- Power supply (GND) 
3. GND-- Power supply (GND) 
4. NC--No connect 
5. NC--No connect 
6. LED-- Pick IO control backlight off or PWM brightness control 
7. CLK--SPI clock signal 
8. SDI--Serial data input pin 
9. RS--Command (RS=0)/ Parameter (RS=1) 
10. RST--Reset Pin 
11. CS-- Chip selection pin

5 PIN Expand wiring used IO: 
1. SD_CS: SD Cars chip selection pin 
2. SD_MOSI: MOSI input 
3. SD_MISO: MISO output 
4. SD_SCK: PI clock signal 
5. F_CS: SPI FLASH signal 

Package Include:
1 x 2.2 inch TFT LCD Module