TB6612 Four Channel DC And Stepper Motor Driver Module [4.5V-13.5V] [1.2A]

TB6612 Four Channel DC And Stepper Motor Driver Module [4.5V-13.5V] [1.2A]
  • Brands CJMCU
  • Product Code:SQ3341
  • Availability: In Stock
  • $11.83
  •  
  • Ex Tax:$11.83
+
-


Tags: DC Motor Driver, Stepper Motor Driver, H Bridge Driver, TB6612, 4Chanel Driver, CJMCU9612, PCA9685, Stepper FeatherWing

Description:
TB6612 Four Channel H Bridge DC And Stepper Motor Driver Module is a 4 channel, stepper motor driver and controller board for Arduino, which is based on two TB6612 IC and another chip, known as  PCA9685. The TB6612 chip is a driver IC for DC and stepper motor with output transistor in LD MOS structure with low ON-resistor. The first  input signals, IN1 and second input signals, IN2, can select one of these four modes: CW, CCW, short break, and stop mode. The TB6612 produces 1.2A per bridge (3A peak) with thermal shutdown protection, internal kickback protection diodes and can drive motors on 4.5VDC to 13.5VDC. This 4 channel driver can drive and control  two bi-polar stepper motors or fore brushed DC motor, or one stepper and two DC motors.
Also the PCA9685 chip is a fully-dedicated PWM driver chip, and a good replacement of using a latch and the PWM pins which handles all the motor and speed controls over I2C. By using I2C (SDA & SCL pins), it works with any and all Feathers- ATmega32u4, ATSAM M0 or ESP8266-based. It can be stacked with any other FeatherWing or with itself (each wing with a unique I2C address). By applying an appreciate feather stacking headers or feather female headers, user can connect it to a  FeatherWing  and make a flight gadget.

Features:
Full H-Bridges: 1.2A per bridge (3A peak) 
Can run motors on 4.5VDC to 13.5VDC.
Up to 4 bi-directional DC motors with individual 12-bit speed selection (so, about 0.02% resolution)
Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil, interleaved or micro-stepping.
Motors automatically disabled on power-up
Big 3.5mm terminal block connectors to easily hook up wires (18-26AWG) and power
Polarity protected 2-pin terminal block and jumper to connect external power, for separate logic/motor supplies.
Size: 55mm x 25mm

Package Includes:
1 x CJMCU TB6612 DC Stepper Motor Driver

Electrical Parameters
Operating Voltage 4.5V ~ 13.5V
Current 1.2A (3A Peak)
Physical Parameters
Size 55mm x 25mm

Write a review

Note: HTML is not translated!
   Bad           Good
Captcha
Electronic & Robotic Supplier

Your B2B Supplying Partner in Mainland China

Worldwide Shipping

Using Vast Majority of International Couriers

Secure Payments

Always Pay with Trust by PayPal Express Checkout