5 PCS SDK08 Test Hook Clips For SMD PIN Socket

The SDK08 test hook clip is designed for clamping small-pitch SMD chip pins with a pitch greater than 0.3mm. The clip body is fully insulated and non-conductive, preventing accidental shorts during testing. Perfect for PCB diagnostics, signal probing, soldering work, and electronics repair. The push-on/push-off design ensures gentle engagement and removal without damaging delicate chip pins.

Insulated & Non-Conductive – Safe for Live Circuit Testing

• The SDK08 clip body is covered with isolation material and is completely non-conductive. This means:
• No accidental shorts – the insulated body won't bridge adjacent pins
• Safe for live circuits – work on powered boards with confidence
• No signal interference – insulation prevents capacitive coupling
• Clamping Method for Small-Pitch Chip Pins

To Attach the SMD PIN Socket Adapter:

• Push the clamp opening to approximately the size of a single chip pin.
• Gently shake your hand while pushing the clip slightly forward.
• The clip will engage around the pin without forcing or damaging the component.

To Remove the Clip (Important!):

• Do NOT forcibly pull off the clip after use.
• Correct procedure: Push the clip opening to release, then gently remove it from the chip pin.
• Forcible removal can bend or lift SMD pads.
• Adjustable Tension – Fix Loose Clamping

If the clip becomes loose over time or won't grip tightly:

• Use fine tweezers to adjust the front end of the clamp.
• Bend the tip so the gripping angle is close to 90 degrees.
• Test on a spare pin – tension should be restored.
• This simple adjustment extends the life of the clip indefinitely.

SMD PIN Socket Adapter Application:

1. PCB diagnostics: Attach to individual IC pins for signal measurement
2. Oscilloscope probing: Hands-free connection to fine-pitch components
3. Logic analyzer connection: Secure grip on multiple pins simultaneously
4. Soldering assistance: Hold wires or components to adjacent pins
5. Firmware flashing: Connect programming leads to test points
6. Repair work: Isolate and test specific pins on damaged ICs

Test Hook Clip for SMD Pins Specification:

1. Model: SDK08
2. Rated Voltage: 40V
3. Rated Current: 2A
4. Material: ABS (insulated, non-conductive)
5. Min Pin Pitch: >0.3mm

Features:

1. Insulated & Non-Conductive: Clip body covered with isolation material – no conductivity, safe for live circuit testing.
2. Small-Pitch Compatible: Clamps chip pins with pitch greater than 0.3mm – ideal for fine-pitch SMD components.
3. Gentle Clamping Method: Push clip opening to match pin size, gently slide forward – no force or prying required.
4. Proper Removal: Push to release, then gently remove – never forcibly pull off.
5. Adjustable Tension: Use tweezers to adjust front clamp angle to near 90 degrees if clamping becomes loose.
6. Durable ABS Construction: Lightweight, impact-resistant housing.
7. Electrical Ratings: Rated at 40V / 2A – suitable for signal-level and low-power testing.