Pre-amplifier Module with AD828 Op Amp

Pre-amplifier Module with AD828 Op Amp
Click image for Gallery
  • Product Code:SQ12036
  • Availability: 1000
  • $1.10
  •  
  • Ex Tax:$1.10
+
-


Tags: AD828, amplifier, preamplifier, op amp

Descriptions:
Preamplifier module with op amp AD828 is a stereo or two-channel preamplifier module based on IC AD828, which works with a voltage of 5 to 15 volts.
One of the capabilities of this module is to adjust the signal amplification factor with resistors R7 and R5 (by default, the amplification is about 5 times.) You can change the amplification factor according to your needs. Resistors can be selected from 5k-47k. The larger the resistors, the greater the amplification. If you are using plug-in resistors, you can remove the resistors from the main board and solder them to the embedded pads on both ends of the chip.
Note: This microphone amplifier board does not have a power supply voltage regulator circuit and can only use a battery or linear power supply and cannot use a switching power supply, otherwise interference will occur. If one channel is always used, the other channel should be shorted to GND to prevent mutual signal interference.

Application:
Switch and sensor for Arduino STM
Electronic module
Computer
Can be used for guitar and other musical instruments

Specifications:
Size: 33mm*25mm
Working voltage: DC 5v-15v
Operating temperature: -40 - +85
Bandwidth: 130 MHz, 3 dB

AD828 op amp data sheet

Write a review

Note: HTML is not translated!
   Bad           Good
Captcha
Electronic & Robotic Supplier

Your B2B Supplying Partner in Mainland China

Worldwide Shipping

Using Vast Majority of International Couriers

Secure Payments

Always Pay with Trust by PayPal Express Checkout