LCR-TC1 Multi-functional Electronic Component Tester

Description:
This is an LCR-TC1 Multi-functional Electronic Component Tester that can be widely used to detect NPN and PNP transistor, capacitor, resistor, diode, triode, N-channel, and P-channel MOSFET, IGBT, JFET, Triac, and battery, etc. It can also be used to detect infrared waveforms, Zener diode and includes the function of self-calibration.
After detection, align the infrared remote control with the “IR” light, then press the button on the remote control, if the detector successfully decodes it, it will display the data code and infrared waveform.
One button operation automatically detects and shutdown, and you can press the multi-functional button to close the detector too.
Put the pins of the component in the corresponding area, then dial the little handle and the detector will test it automatically, finally, the results will display on the backlight TFT screen clearly.

Attention: All ways be sure to discharge capacitors before connecting them to the Tester! The Tester may be damaged before you have switched it on. There is only a little protection at the MCU’s ports. Extra caution is required if you try to test components mounted in a circuit. In either case, the equipment should be disconnected from the power source and you should be sure, that no residual voltage remains in the equipment.

LCR-TC1 tester Application:

1. quality control of component
2. repairing and reworking

LCR-TC1 tester Specifications:

1. Display: 1.8 inch TFT Screen
2. Diode Range: < 4.5V
3. Zener Diode:Transistor Detect Area: 0.01V ~ 4.5V
4. Zener Diode Detect Area: 0.01 ~ 30V
5. Triac Range: IGT < 6mA
6. Capacitance: 25pF ~ 100mF
7. Resistor: 0.01 ~ 50MΩ
8. Inductance: 0.01mH ~ 20H
9. Battery: 0.1V ~ 4.5V
10. Self Calibration function
11. Power Mode: Rechargeable Lithium Battery ( NOT INCLUDED)
12. Size: 88mm x 80mm x 28mm

Document:

1. TC1 Multi-function tester review Link