CJMCU-TPIC6C596 Seven Segment Shift Register Module

Description:

The MCU Large Digit Driver can easily be attached to the back of the 7-segment display by soldering all 10 castellations pins at the bottom of the board as well as the two additional castellations at the top. Keep in mind that the Large Digit Driver requires both 12V for the LEDs and 5V for the on-board TPIC6C596 IC. Each driver is equipped with six input pins and six output pins, these make the driver capable of being chained together. The input/output pins are listed as GND (Ground), LAT (Latch), CLK (Clock), SER (Serial), 5V (Power for the driver IC), and 12V (Power for the 7-segment display). 

Application:
Instrumentation Clusters
Tell-Tale Lamps
LED Illumination and Controls
Automotive Relay or Solenoids Drivers

Specifications:
Typical Operating Voltage: 5V
Operating voltage range: 4.5 ~ 5.5 v
VIH: 0.85*VCC
VIL: 0.15*VCC
SETUP TIME: 15 NS
Drain-source breakdown voltage: 33v
Chainable to another Large Digit Driver
Attaches directly to the 7-Segment Display
Castellated Mounting Holes

TPIC6C596 IC datasheet