ATtiny85-20SU Microcontroller [8 Pins]

Description:
The ATtiny85 is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture.
By executing powerful instructions in a single clock cycle, the ATtiny85 achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.
The high-performance microcontroller combines 8KB ISP flash memory, 512B EEPROM, 512-Byte SRAM, 6 general-purpose I/O lines, 32 general purpose working registers, one 8-bit timer/counter with compare modes, one 8-bit high-speed timer/counter, USI, internal and external Interrupts, 4-channel 10-bit A/D converter, programmable watchdog timer with internal oscillator, three software selectable power saving modes, and debugWIRE for on-chip debugging. The device achieves a throughput of 20 MIPS at 20 MHz and operates between 2.7-5.5 volts.

Features:
High Performance, Low Power AVR® 8-Bit Microcontroller
Advanced RISC Architecture:
   – 120 Powerful Instructions
   – Most Single Clock Cycle Execution
   – 32 x 8 General Purpose Working Registers
   – Fully Static Operation
Non-volatile Program and Data Memories: 
   – 8KBytes of In-System Programmable Program Memory Flash
          • Endurance: 10,000 Write/Erase Cycles
   – 512Bytes In-System Programmable EEPROM
          • Endurance: 100,000 Write/Erase Cycles
   – 512Bytes Internal SRAM
   – Programming Lock for Self-Programming Flash Program and EEPROM Data Security
Peripheral Features: 
   – 8-bit Timer/Counter with Prescaler and Two PWM Channels
   – 8-bit High-Speed Timer/Counter with Separate Prescaler
          • 2 High-Frequency PWM Outputs with Separate Output Compare Registers
          • Programmable Dead Time Generator
   – USI – Universal Serial Interface with Start Condition Detector
   – 10-bit ADC
          • 4 Single-Ended Channels
          • 2 Differential ADC Channel Pairs with Programmable Gain (1x, 20x)
          • Temperature Measurement
   – Programmable Watchdog Timer with Separate On-chip Oscillator
   – On-chip Analog Comparator 
Special Microcontroller Features:
   – debugWIRE On-chip Debug System
   – In-System Programmable via SPI Port
   – External and Internal Interrupt Sources
   – Low Power Idle, ADC Noise Reduction, and Power-down Modes
   – Enhanced Power-on Reset Circuit
   – Programmable Brown-out Detection Circuit
   – Internal Calibrated Oscillator
Operating Voltage: 2.7V ~ 5.5V
Speed Grade: 0 ~ 10MHz (at 2.7V ~ 5.5V), 0 ~ 20MHz (at 4.5V ~ 5.5V)
Temperature Range: -40°C ~ +85°C
Low Power Consumption
Pin Number: 8 Pin
I/O Pin: 6 Pin
Package: SOP8

Package Include:
1 x ATTINY85-20SU Microcontroller