RF-NANO Arduino

This board combines the NRF24L01+ wireless transceiver with the familiar form factor and programming paradigm of the Arduino Nano.

The main chip is ATMEGA328P-MU QFN32,the latest bootloader (Arduino IDE 1.8.8) was burned down. It is fully compatible with the common nano board. RF-Nano-Board is PIN-PIN with Arduino Nano V3.0, and share the same codes.

The NRF2401+ is a very capable wireless unit, allowing for data transfer between two Arduinos or similar boards with a fairly straightforward setup programming-wise.

This board combines the NRF24L01+ wireless transceiver with the familiar form factor and programming paradigm of the Arduino Nano. For someone who needs wireless capabilities and prefers to keep solder and wiring work to a minimum, this appeared to be a wish come true. After a bit of yak shaving, it appears to fit the bill very well, and this article will help you avoid a couple possible pitfalls.

CH340 driver was needed. After running the program and doing a restart, it recognized the RF-Nano without a problem.

electronic projects

IOT

remote control

Microcontroller: ATmega328P-MU QFN32

Bootloader: Newest 1.8.8

Wireless: Nrf24L01+ 2.4G

BLE chip: TI CC2540

Work channel: 2.4G

Transmission distance: 50m

Architecture: AVR

Input voltage: USB power supply, Vin 6-12V

Operating Voltage: 5V

Flash Memory: 32KB of which 2KB used by bootloader

SRAM: 2KB

Clock Speed: 16MHz

Analog I/O Pins: 8

EEPROM: 1KB

DC Current per I/O Pins: 40mA (I/O Pins)

Input Voltage: 7-12V

Digital I/O Pins: 12

PWM Output: 6

Power Consumption: 19mA

Interface: Micro-USB

Pin: Two Lines 2.54mm-15Pin

Dimensions: 48x19x12mm

Weight: 9g