366D Manual Desoldering Pump – 20 cm, Dual-Ring Suction, ABS Body, Black

The 366D is a manual desoldering pump designed for removing solder from printed circuit boards during repair, rework, and component replacement. It uses a spring-loaded piston that is compressed with the thumb and released by a button, creating a strong vacuum that draws molten solder away from the joint and through-hole. The dual-ring airtight seal helps maintain suction pressure and reduces air leakage, which is important when working on small pads and fine-pitch components where a weak vacuum would leave solder behind. The body is made from hard ABS plastic and the handle incorporates a heat-resistant sponge, giving the tool durability for repeated use near a soldering iron. At 20 cm in length, it is compact enough to fit into crowded work areas while still providing enough leverage for one-handed operation. The black finish and simple push-button release make it straightforward to use: compress the piston, heat the joint, place the nozzle over the molten solder, and press the release. This 366D desoldering pump is suitable for electronics education, PCB repair, and general bench work where a reliable manual solder sucker is preferred over a powered desoldering station.

1. Removing solder from PCB joints and through-holes during repair.
2. Desoldering components for replacement or salvage.
3. Electronics education and soldering practice.
4. Correcting soldering mistakes on prototype and production boards.
5. General bench work requiring a manual solder sucker.
6. Field repair and maintenance of electronic assemblies.

1. Model: 366D (Pro'sKit DP-366D per cross-reference).
2. Product type: manual spring-loaded desoldering pump (solder sucker).
3. Length: 20 cm (Aftab listing); 210 mm per Pro'sKit specification.
4. Body material: hard ABS plastic.
5. Handle: anti-slip design with heat-resistant sponge.
6. Suction capacity: up to 32 cm-Hg (per Pro'sKit specification).
7. Seal design: dual airtight rings for reduced air leakage.
8. Operation: one-handed push-button release.
9. Colour: black.
10. Nozzle: replaceable (per Pro'sKit specification).
11. Weight: approximately 85 g (per Little Bird Electronics).
12. Dimensions (per Little Bird Electronics): 30 × 30 × 205 mm.