Six-axis MPU6050 QFN24 Sensor Chip A

Six-axis MPU6050 QFN24 Sensor Chip A
Click image for Gallery
  • Product Code:SQ11014
  • Availability: 1000
  • $1.30
  •  
  • Ex Tax:$1.30
This product has a minimum quantity of 5
+
-


Tags: IC accelerometer, gyroscope, MPU-6050 6AXIS

Description:
The MPU 6050 QFN-24 6-Axis Gyro/Accelerometer IC incorporates InvenSense’s MotionFusion and run-time calibration firmware that enables manufacturers to eliminate the costly and complex selection, qualification, and system level integration of discrete devices in motion-enabled products, and guarantees that sensor fusion algorithms and calibration procedures deliver optimal performance for consumers.
By combining a MEMS 3-axis gyroscope and a 6-axis accelerometer on the same silicon die together with an onboard Digital Motion Processor™ (DMP™) capable of processing complex 9-axis MotionFusion algorithms, the MPU-6050 does away with the cross-axis alignment problems that can creep up on discrete parts. The parts’ integrated 9-axis MotionFusion algorithms can even access external magnetometers or other sensors through an auxiliary master I2C bus, allowing the devices to gather a full set of sensor data without intervention from the system processor.
For precision tracking of both fast and slow motions, the MPU-6050 features a user-programmable gyro full-scale range of ±250, ±500, ±1000, and ±2000°/sec (dps) and a user-programmable accelerometer full-scale range of ±2g, ±4g, ±8g, and ±16g.

Application:
Blurfree technology
AirSighn Technology
Motion Game controller
Smart Phones
Laptop
etc.

Features:
User-programmable digital filters for gyroscope, accelerometer, and temp sensor
Digital-output temperature sensor
Auxiliary master I2C bus for reading data from external sensors
Minimal cross-axis sensitivity between the accelerometer and gyroscope axes
MEMS structure hermetically sealed and bonded at the wafer level
400kHz fast mode I2C for communicating with all registers
Applications: Consumer Electronics, Sensing & Instrumentation, Automation & Process Control, System Monitoring, Robotics.
Tri-Axis angular rate sensor (gyro) with a sensitivity up to 131 LSBs/dps and a full-scale range of ±250, ±500, ±1000, and ±2000dps
Tri-Axis accelerometer with a programmable full-scale range of ±2g, ±4g, ±8g and ±16g
Reduced settling effects and sensor drift by the elimination of board-level cross-axis alignment errors between accelerometers and gyroscopes
9-Axis Digital Motion Processing (DMP) engine offloads complex MotionFusion, sensor timing synchronization and gesture detection
Embedded algorithms for run-time bias and compass calibration. No user intervention required
Digital-output temperature sensor
Digital input on FSYNC pin to support video Electronic Image Stabilization and GPS
Programmable interrupt supports gesture recognition, panning, zooming, scrolling, free fall interrupt, high-G interrupt, zero-motion detection, tap detection, and shake detection
VDD Supply voltage range of 2.375V–3.46V
VLOGIC at 1.8V±5% or VDD
On-chip timing generator with ±1% frequency variation over the full temperature range
10,000g shock tolerant.

Write a review

Note: HTML is not translated!
   Bad           Good
Captcha
Electronic & Robotic Supplier

Your B2B Supplying Partner in Mainland China

Worldwide Shipping

Using Vast Majority of International Couriers

Secure Payments

Always Pay with Trust by PayPal Express Checkout