ANENG M469D Network Cable Tester

It is one of the main needs of network engineers, and with the help of this device, you can ensure the correctness of your performance in cable crimping. If network troubleshooting has been assigned to you, you can make sure of the correct operation of the cables and move on to the next stages of network troubleshooting.

The ANENG M469D network tester has the ability to test RJ45 and RJ11 network cables and is suitable for checking the correct connections of network cables and telephone wiring lines and detecting possible faults along the cable path, for quick troubleshooting without causing damage to the relevant cables. The network cable tester consists of two separate parts, each of which has 9 LED lights. By installing the connectors related to both ends of a network or telephone cable path to each of the two parts of this device and turning on its switch, all the wires inside the cable are scanned, and by the sequential lighting of the LEDs, the existence of a fault or the correctness of the cable is determined. In the main part of the device, a 9-volt rectangular battery is responsible for powering the device.

If any of the cables is cut, the LED for that cable is off, and if several cables are cut, several consecutive LEDs are off and the rest are on. If fewer than two cables are connected, none of the LEDs will light up.

Note:Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures.

Test of double-twisted cables: Switch on the power. (S is slow automatic grade, Mis manual.) Put cables into both main tester and remote tester. The lights of the main tester will turn on sequently form 1 to G.

Main tester: 1-2-3-4-5-6-7-8-G

Remote tester: 1-2-3-4-5-6-7-8-G RJ45, 1-2-3-4-5-6 RJ11

Following are abnormal connections:

If one cable, for example cable NO.3 is open circuited, the two NO.3 lights of the main tester and remote tester will not turn on.

If several cables are not connected, several lights will not turn on respectively. If less than two cables are connected, none of the lights is on.

If two ends of a cable is disordered, for example NO. 2and NO. 4, then displays on:

Main tester: 1-2-3-4-5-6-7-8-G

Remote tester: 1-4-3-2-5-6-7-8-G

If two cables are short circuited, neither of the corresponding lights is on of the remote tester while main tester remains unchanged. If three cables, including three, are short circuited, none of the corresponding lights is on. If test patch panels or wall plate outlets, two cables which can match each other (RJ45) will be connected to the tester.

If test cables of the same axes, BNC turns on when the cable works.

Network Cable Tester Application:

1. RJ45 Cable Socketing
2. RJ11 Cable Testing

Network Cable Tester Specification:

1. Color: Black, Yellow
2. Material: ABS plastic
3. Size: 103x97x27mm/4.06x3.82x1.06in
4. Power supply: 9V 6F22 battery (not included)
5. Interface end: RJ45+RJ11