ESP32 Stepper Motor Driver Board 4988 12V 2A CNC, 3D Printer

The A4988 stepper motor driver board is suitable for starting stepper motors in a 3D printer because the accuracy of the motor movement is important in printing. This driver is a versatile control board and the ESP32 microcontroller with dual-core processing capability, Wi-Fi And it integrates Bluetooth with A4988 stepper motor drivers, which can control stepper motors up to 12V and 2A per phase, it also has ch340c converter chip.

Marlin, Grbl or custom firmware: Install firmware compatible with your application (3D printing, CNC, etc.).

Connect the stepper motors to the A4988 drivers.

Ensure proper configuration of microstepping and current limits in drivers.

Connect a 12V power supply that can provide enough current for your motors.

If working with high currents, ensure proper cooling for the drivers.

Use the ESP32's Wi-Fi capabilities to control the board wirelessly.

Calibrate motor stages, current limits, and terminals using firmware commands.

Connect terminals to ensure accurate homing and limit detection.

Connect any additional peripherals required for your specific application.

CNC machines

3D printers

Laser engraving machines

Robotic

Processor: Tensilica LX6 dual-core up to 240 MHz

Wi-Fi: 802.11 b/g/n.

Bluetooth: Version 4.2 BR/EDR and BLE

Flash memory: 4 MB

RAM: 520 KB

Stepper motor drivers

Driver model: A4988

Voltage: 8 to 35 volts

Current: Maximum 2 amps per coil

Microstepping: full step, 1/2, 1/4, 1/8 and 1/16 step

Voltage: 12 volts

Current: 2A

GPIO pins: for additional sensors and peripherals

I2C, SPI, UART: communication protocols supported by ESP32